Rainbow Electronics DS1854 - Manual (Page 16)

DS1854
Dual Temperature-Controlled Resistors with
Two Monitors
16 ____________________________________________________________________
MEMORY
LOCATION
EEPROM/
SRAM
R/W
DEFAULT
SETTING
NAME OF
LOCATION
FUNCTION
80 SRAM R/W — Mode —
Bit 7 — — 0 X —
6 — — 0 X —
5 — — 0 X —
4 — — 0 X —
3 — — 0 X —
2 — — 0 X —
1 — — 1 TEN
If TEN = 0, the temperature conversions update and the
resistors can be controlled manually. The user sets the
resistor in manual mode by writing to addresses 82h and
83h in Table 01 to control resistors 0 and 1, respectively.
0 — — 1 AEN
AEN = 0 provides manual control of the temperature
index.
81 SRAM R — Temp index
This byte is the temperature-calculated index used to
select the address of resistor settings in the look-up
tables.
82 SRAM R/W 00 Resistor 0 Resistor 0 position values from 00h to FFh.
83 SRAM R/W 00 Resistor 1 Resistor 1 position values from 00h to FFh.
84 to 87 SRAM 00 Reserved —
88 EEPROM R/W — Interrupt enable
This byte configures a maskable interrupt, determining
which event asserts a buffer 1 output (MINT set to 1, see
register 89h in Table 01). If any combination of
temperature, V
CC , MON1, or MON2 is desired to generate
an interrupt, the corresponding bits are set to 1. If
interrupt generation is not desired, set all bits to 0.
Bit 7 — — 1 TMP —
6 — — 1 V CC —
5 — — 1 MON1 —
4 — — 1 MON2 —
3 — — 0 X —
2 — — 0 X —
1 — — 0 X —
0 — — 0 X —
89 EEPROM R/W — Configuration —
Bit 7 — — 0 X —
6 — — 0 X —
Table 01h