Data polling eeprom, Data polling flash, Figure 36 – Rainbow Electronics AT90LS2343 User Manual

Page 44

AT90S/LS2323/2343

1004D–09/01

At the end of the programming session, RESET can be set high to commence
normal operation.

Power-off sequence (if needed):

Set CLOCK/XTAL1 to “0”.

Set RESET to “1”.

Turn V

power off.

Data Polling EEPROM

When a byte is being programmed into the EEPROM, reading the address location
being programmed will give the value P1 until the auto-erase is finished, and then the
value P2 will be given. See Table 18 for P1 and P2 values.

At the time the device is ready for a new EEPROM byte, the programmed value will read
correctly. This is used to determine when the next byte can be written. This will not work
for the values P1 and P2, so when programming these values, the user will have to wait
for at least the prescribed time t

WD_PROG

before programming the next byte. See Table 22

for t

WD_PROG

value. As a chip-erased device contains $FF in all locations, programming

of addresses that are meant to contain $FF can be skipped. This does not apply if the
EEPROM is reprogrammed without first chip-erasing the device.

Data Polling Flash

When a byte is being programmed into the Flash, reading the address location being
programmed will give the value $FF. At the time the device is ready for a new byte, the
programmed value will read correctly. This is used to determine when the next byte can
be written. This will not work for the value $FF, so when programming this value, the
user will have to wait for at least t

WD_PROG

before programming the next byte. As a chip-

erased device contains $FF in all locations, programming of addresses that are meant
to contain $FF can be skipped.

Figure 36. Low-voltage Serial Downloading Waveforms

Table 18. Read Back Value during EEPROM Polling

Part

AT90S2323

$00

$FF

AT90S2343

$00

$FF

MSB

LSB

SERIAL CLOCK INPUT

PB2(SCK)

SERIAL DATA INPUT

PB0(MOSI)

SERIAL DATA OUTPUT

PB1(MISO)