Rainbow Electronics ADC12L063 - Manual (Page 3)

Pin Descriptions and Equivalent Circuits
Pin No. Symbol Equivalent Circuit Description
ANALOG I/O
2 V
IN+
Non-Inverting analog signal Input. With a 1.0V reference
voltage the input signal level is 1.0 V
P-P
.
3 V
IN−
Inverting analog signal Input. With a 1.0V reference voltage
the input signal level is 1.0 V
P-P
. This pin may be connected
to V
CM
for single-ended operation, but a differential input
signal is required for best performance.
1 V
REF
Reference input. This pin should be bypassed to AGND with
a 0.1 µF monolithic capacitor. V
REF
is 1.0V nominal and
should be between 0.8V and 1.2V.
31 V
RP
These pins are high impedance reference bypass pins only.
Connect a 0.1 µF capacitor from each of these pins to AGND.
DO NOT connect anything else to these pins.
32 V
RM
30 V
RN
DIGITAL I/O
10 CLK
Digital clock input. The range of frequencies for this input is 1
MHz to 70 MHz (typical) with guaranteed performance at 62
MHz. The input is sampled on the rising edge of this input.
11 OE
OE is the output enable pin that, when low, enables the
TRI-STATE data output pins. When this pin is high, the
outputs are in a high impedance state.
8 PD
PD is the Power Down input pin. When high, this input puts
the converter into the power down mode. When this pin is
low, the converter is in the active mode.
ADC12L063
www.national.com 3