Rainbow Electronics MAX9013 - Manual (Page 3)

MAX9010–MAX9013
SC70, 5ns, Low-Power, Single-Supply,
Precision TTL Comparators
_______________________________________________________________________________________ 3
ELECTRICAL CHARACTERISTICS (MAX9010/MAX9011) (continued)
(V CC = 5V, V LE = 0 (MAX9011 only), V CM = 0, T A = T MIN to T MAX , unless otherwise noted. Typical values are at T A = +25°C.) (Note 1)
PARAMETER SYMBOL CONDITIONS MIN TYP MAX UNITS
Latch Setup Time (Note 8) t SU MAX9011 only 2 0 ns
Latch Hold Time (Note 8) t H MAX9011 only 2 0.5 ns
Latch Propagation Delay
(Note 8)
t LPD MAX9011 only 5 ns
Input Noise-Voltage Density e n f = 100kHz 6 nV/ √Hz
V OVERDRIVE = 100mV 5 8 C LOAD = 5pF,
T A = +25°C V OVERDRIVE = 5mV 5.5 9
V OVERDRIVE = 100mV 9
Propagation Delay (Note 6) t PD+ , t PD-
C LOAD = 5pF,
T A = T MIN to T MAX V OVERDRIVE = 5mV 10
ns
Output Rise Time t
R
0.5V ≤ V
OUT
≤ 2.5V 3 ns
Output Fall Time t F 2.5V ≥ V
OUT
≥ 0.5V 2 ns
MAX9010EXT 0.8
Input Capacitance C IN
MAX9011EUT 1.2
pF
Power-Up Time t ON 1 µs
ELECTRICAL CHARACTERISTICS (MAX9012/MAX9013)
(V CC = 5V, V LE = 0 (MAX9013 only), V CM = 0, T A = T MIN to T MAX , unless otherwise noted. Typical values are at T A = +25°C.) (Note 1)
PARAMETER SYMBOL CONDITIONS MIN TYP MAX UNITS
Supply Voltage Range V
CC
Inferred from PSRR test 4.5 5.5 V
MAX9012 2.4 4.2
Power-Supply Current (Note 2) I CC
MAX9013 1.3 2.3
mA
T A = +25°C ±0.7 ±3 Input Offset Voltage
(Note 5)
V OS
T A = T MIN to T MAX ±5.5
mV
Input Offset-Voltage Drift ∆V
OS/
∆T ±2 µV / °C
Input Bias Current I B ±0.5 ±2 µA
Input Offset Current I OS ±40 ±200 nA
Differential Input Resistance
(Note 4)
R IN (D IFF) V IN(DIFF) = ±10mV 250 k Ω
Common-Mode Input
Resistance (Note 4)
R IN(CM) -0.2V ≤ V
CM
≤ (V
CC - 1.9V) 1 M Ω
Common-Mode Input Voltage
Range (Note 4)
V CM Inferred from CMRR test -0.2 V CC - 1.9 V
Common-Mode Rejection
Ratio
CMRR -0.2V ≤ V
CM
≤ (V
CC - 1.9V) 75 95 dB
Power-Supply Rejection Ratio PSRR V CC = 4.5V to 5.5V 63 82 dB