3 software features, 1 software features – Rainbow Electronics WE865-DUAL User Manual
Page 13
WE865-DUAL Product Description
80312ST10046A Rev. 1 - 03/10/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 13 of 22
3 Software features
Linux Operating System and Linux WiFi Software Framework are used to configured and controlled
WE865-DUAL and help interfacing it with the GE863-PRO
3
.
3.1 Software features
• Active scan for networks in the local area
• Connection to infrastructure (access point) or independent (ad-hoc) networks
• Starting an unsecured or security-enabled (WEP encrypted) independent (ad-hoc) network.
• Connection to security-enabled (WPA/WPA2 encrypted) networks
EAP Method supported:
•
EAP-TLS
•
EAP-PEAP/MSCHAPv2 (both PEAPv0 and PEAPv1)
•
EAP-PEAP/TLS (both PEAPv0 and PEAPv1)
•
EAP-PEAP/GTC (both PEAPv0 and PEAPv1)
•
EAP-PEAP/OTP (both PEAPv0 and PEAPv1)
•
EAP-PEAP/MD5-Challenge (both PEAPv0 and PEAPv1)
•
EAP-TTLS/EAP-MD5-Challenge
•
EAP-TTLS/EAP-GTC
•
EAP-TTLS/EAP-OTP
•
EAP-TTLS/EAP-MSCHAPv2
•
EAP-TTLS/EAP-TLS
•
EAP-TTLS/MSCHAPv2
•
EAP-TTLS/MSCHAP
•
EAP-TTLS/PAP
•
EAP-TTLS/CHAP
•
EAP-PSK
• Operation as an independent station (in infrastructure and ad hoc networks)
• A Management Information Base (MIB), used mainly for system configuration, such as setting
the MAC address, with values downloaded from the host or from non-volatile memory during
system initialisation
• 802.11i security enhancements (except STAKey)
• The firmware’s default MIB contents can be initialised from an EEPROM. This can be used to
set basic per-design and per-device data, such as the radio’s MAC address.
• Basic receive radio strength and signal quality data are available via the MIB
• Basic power saving (both IEEE 802.11 protocol and chip sleep modes)
• Host wake up signalling
• Host handshaking for deep sleep