TC Electronic M2000 - Manual (Page 23)

23
DYNAMIC MORPHING
Dynamic Morphing
The Dynamic Morphing function is a great new way of interac-
tion between your source signal and the Effect.
When activated, the M2000 will morph between the two Engines
according to your Input level. This is a function for quick seam-
less changes of an Effect.
Think about the vocal in a ballad being soft and subtle during the
verse and then rising to heartbreaking heights in the chorus. Now
imagine the Reverb changing along with it, from a small discreet
Room in the verse, to a Big Bright Hall in the chorus.
Simply select the two presets in the current Engines and then
activate the Dynamic Morphing function. Set the Threshold and
the Speed of the Dynamic Morphing and check out the result.
Morph direction 1-2:
If this box is selected, Engine 1 will be active while the Input is
below Threshold.
Morph direction 2-1:
If this box is selected, Engine 2 will be active while the Input is
below Threshold.
Note that the max. level of the Engines is set by the Engine Out
bars above Dynamic Morphing.
The Dynamic Morphing is Stored along with Combined Presets.
The Dynamic Morphing function is only available when Routing
is set to Parallel.
Engine output levels
Engine output levels [mix]
Dynamic Morphing section
Morphing threshold
Morphing speed
Morphing on/off and
morphing direction