TC Electronic M2000 - Manual (Page 21)

21
MIDI MONITOR & TUNER
Tuner
Press Shift - Routing to access the Tuner of the M2000.
When Tuner is selected, the Outputs will be muted.
Select Guitar/Bass/Manual mode by turning the ADJUST wheel.
When Guitar or Bass is selected, the Tuner will only respond to
notes corresponding to the strings of these instruments.
When set to Manual, you must select the desired Note using the
ADJUST wheel.
In the Master section, you can Calibrate the Tuners default, 440-
445 Hz.
The detected note will be shown in the lower right corner and in
the note line. When the horizontal marker is 0, you are tuned in.
The two tuning guides will tell you wether the note is too flat or
too sharp.
Press any key to exit Tuner.
MIDI Monitor
Press Shift - Util/Midi to access MIDI Monitor.
In the MIDI Monitor, you are able to see all MIDI actions
received by the M2000. The actions are displayed according to
the current channels.
Prog. Displays Program changes.
Note Displays Note On/Off.
Cntl Displays Control changes
Sys-x Displays System exclusive commands
Eng Displays the midi channels of Eng 1,2 and combined.
Chan Displays the Midi channels
Press any key to exit MIDI Monitor.
Program changes
Channel pointer
Tuning guide
Tuning guide
»MIDI MONITOR SCREEN«
»TUNER SCREEN«
Note on/off
Controllers
System exclusive
Engines MIDI channels
Select guitar/bass
or note set manual
Master tune 440-445Hz
Detected note
Deviation in cents