TC Electronic TouchMonitor - Manual (Page 13)

EN-13 Manual | TouchMonitor TM7/TM9 Installation
EN
Installation
The TouchMonitor TM7 and TM9 table-top units (20700/20900) are
designed for free positioning on tables, desks, et. al. All necessary
power supply voltages are supplied through the +24 V DC 1 A con-
nector. Use with power supply model STD-2427PA, manufactured
by Adapter Technology Co Ltd. (which is the external power supply
unit RTW 1168-R wide voltage power supply, included in 20700 and
20900 packages). The units feature a 7“ resp. 9“ VGA 16 : 9 touch
screen.
Optional an external standard16 : 9 VGA monitor can be connected
for external reading of the display.
Optional an external computer mouse or a Wacom® graphics tablet
can be connected to one of the USB interfaces.
The other ports and interfaces are connected with the appropriate
standard connection cables.
ATTENTION – Please read before installing:
• Before installing the unit please study the safety instructions and
the information on connection and pin assignment.
• An external overcurrent protective device (2 A max.) shall be
installed when using an external 24 V DC power supply!
• Make sure that the delivered power supply unit is not connected.
• Connect your signal sources and all your other components to the
appropriate connectors, using the correct standard connection
cables for the components. Take care about the pin assignment!
• Optionally, connect an external standard 16 : 9 VGA monitor to
the VGA output, using a standard VGA connection cable. The VGA
cable shall be of 10 to 15 m maximum length.
• Finally, connect the locking 4-pin low voltage connector of the
external power supply to the +24 V DC 1 A connector on the rear.
Connect the external power supply to mains.
• The TouchMonitor will initiate its system startup sequence. After
the boot-up the unit is ready for use.