TC Electronic M-One XL - Manual (Page 9)

7
FRONT PANEL
ROUTING key
Press the ROUTING key to set
the Engine Routing.
The options are: Dual Send/
Ret, Parallel, Parallel/Serial,
Serial, Stereo, Dual Mono.
I/O SETUP
Basic parameters are set here.
• Input source - Analog/Digital.
• Sample Rate -
44.1/48kHz/DI
• Bypass Mode - See Bypass
keys 1 and 2.
• Global Output level.
• Dither 16, 20 or 24(off).
TAP key
Tap this key to enter the global
Tap tempo and to enter the
Tap menu. Subdivision of the
tapped tempo is setup in this
menu. The tapped tempo can
be used for Delay time, Chorus
rate etc.
UTILITY
MIDI, Sys-Ex ID, Routing-lock,
Bypass mode, Pedal function
and Display View angle.
ALGO/EDIT 1+2
Press this key to enter the Edit
display and the Algorithm
Change display of the currently
selected Engine.
BYPASS keys 1 and 2
The Bypass mode is set up in
Utility. There are three different
Bypass modes:
1 0% Mix:
The Input signal is passed
directly to the Output.
2 FX Input:
Cuts only the Engine Input
in order to let the effect "ring
out", but will still leave the
same amount of dry signal
coming through.
3 FX Output:
Cuts only the Engine Output
in order to kill the FX instan-
taneously, but leaves the
same amount of dry signal
coming through.
RECALL key
Selects the Recall menu.
Select a desired preset using
the CONTROL wheel and
press the ENTER key to
enter/load the selected preset.
STORE key
Selects the Store menu.
Presets can be stored in the
User bank only. Location is
selected using the CONTROL
wheel. Operation is confirmed
using ENTER.
CURSOR UP/DOWN
Use the cursors to move
around in the display.
ENTER key
Confirms operations. The
ENTER key LED will indicate
when this key can be used.
EXIT key
Is used to exit a menu or to
disapprove an action.
CONTROL wheel
Is used to change values.