Delay, One tap, Two tap – TC Electronic M-One XL User Manual
Page 29
27
DELAY -
ONE TAP & TWO TAP
One Tap
The One Tap Delay mode operates with one
delay line only.
Delay Time
Range: 0 - 4000ms
The length of the the Delay time.
Feedback
Range: -100 to +100
Controls the amount of signal that is routed
back to the Input of the algorithm. The higher
Feedback value the more repeats you will get.
Pan
Range: 50L - 50R
Controls the panning of the selected voice.
High Cut
Range: 500Hz - 20kHz
High Cut filter that allows you to reduce the
high frequencies of the Delay Taps. This gives
you softer and more analog sounding Delay
Taps which in some cases will seem less
disturbing in the overall sound, than a delay
with no High Cut.
Low Cut
Range: 19.9Hz - 2kHz
Low Cut filter reducing the low end frequencies
of the Delay Taps. When using delay on
signals with low frequencies a full-range delay
might introduce a less tight feeling in the low
frequencies. Use the Low Cut filter to avoid
this.
FX Level
Range: 0 - 100%
The over all level of the Delay.
Two Tap
The Two Tap Delay mode operates with two
Taps, each with its own set of parameters.
Delay Time 1+2
Range: 0 - 4000ms
The Delay time of the Delay tap.
Offset
Range: 0-200ms
Offsets the Delay in the right Channel.
Feedback 1+ 2
Range: -100 to +100
Controls the amount of signal that is routed
back to the Input of the algorithm. The higher
the Feedback value the more repeats you will
get.
Level 1+2
Range: -100 - 0dB
The level of the selected Tap.
Pan 1+2
Range: 50L - 50R
Controls the panning of the selected voice.
High Cut
Range: 500Hz - 20kHz
High Cut filter that allows you to reduce the
high frequencies of the Delay Taps. This gives
you softer and more analog sounding Delay
Taps which in some cases will seem less
disturbing in the overall sound than a delay
with no High Cut.
Low Cut
Range: 19.9Hz - 2kHz
Low Cut filter reducing the low end frequencies
of the Delay Taps. When using delay on
signals with low frequencies a full-range delay
might introduce a less tight feeling in the low
frequencies. Use the Low Cut filter to avoid
this.
FX Level
Range: 0 - 100%
The overall level of the Delay.