TC Electronic M-One XL - Manual (Page 18)

16
RECALL EDIT
Recall
Recalling a Preset
Recalling a preset means loading/activating a
preset.
• Press RECALL to enter the RECALL menu.
• Use the CONTROL wheel to preview
presets.
Preview mode is indicated by blinking preset
number and simultaneously blinking LED in
the ENTER key.
• Press ENTER or RECALL to recall/activate
the preset.
Press the EXIT key during a preview to return
to the current recalled preset.
Preset types
User presets - RAM
User presets that can be edited and stored in
any User location. You can store up to 100
user presets in the User bank.
Factory presets - ROM
Factory presets that can be edited and stored
in any User location. You cannot store presets
into a Factory location.
The M•ONE holds 100 factory presets.
(M•ONE XL - 200)
When you are in the Factory bank you
can press the ARROW UP key to
quickly enter the User bank. Likewise
you can quickly enter the Factory
preset bank by pressing the ARROW
DOWN key.
Edit
Editing a preset on the M•One is quite easy if
you follow the steps below.
Editing the effects currently loaded in the
two Engines:
• Press ALGO/EDIT 1 for Engine 1 or
ALGO/EDIT 2 for Engine 2.
• Depending on the effect currently loaded in
the Engine you will now be at the key
parameter for that particular effect.
- for a Reverb that would be Decay
- for Delay that would be Delaytime etc.
• Adjust the parameter using the CONTROL
wheel or select another parameter using the
ARROW keys.
ARROW keys CONTROL wheel
Changing the type of effects loaded in
Engines 1 or Engine 2:
• Press ALGO/EDIT 1 or ALGO/EDIT 2
• Use the ARROW UP key to go to the
parameter located in the top of the list.
This is where you select which effect you wish
to load in that particular Engine.
• Use the CONTROL wheel to select the
effect type and press ENTER to confirm
your choice.
You may wish to store you edited preset.
Please refer to the storing options described
on the following page of this manual.