TC Electronic TonePrint Editor - Manual (Page 14)

■
Modulation parameters
TC Electronic TonePrint Editor ■ Manual for software version 1 .0 12
Delay Time 3 parameter
Parameter range: 0 .1 to 50 ms
The Delay Time 3 parameter is only applicable
when you have set Modulation Type to TriChorus .
In TriChorus mode, the Delay Time 3 parameter
specifies the length of the delay for the third cho-
rus module .
Feedback parameter
Parameter range: -100 to 100 %
Use the feedback parameter to define the amount
of the signal that is fed back from the modulation
module’s output to its input .
Experiment with the Feedback parameter to get a
feeling for the effects you can achieve .
Feedback HiCut parameter
Parameter range: 20 Hz to 20 kHz
Use the Feedback HiCut parameter to attenuate
the high-end frequencies of the resonance cre-
ated with the Feedback parameter .
Vib. Ramp Time parameter
(Shaker Vibrato only)
Parameter range: 1 to 5000 ms
The Vib(rato) Ramp Time parameter is only avail-
able and editable when a Shaker Vibrato pedal is
connected .
The Vibrato Ramp effect is a subtype of the vi-
brato effect where the effect is latched – i .e ., the
effect will only be applied when you press and
hold the pedal’s footswitch . The Vibrato Ramp
Time parameter sets the time that is required for
the vibrato effect to build up .