Wilwood Forged Narrow Superlite 6R Big Brake Front Brake Kit (Hub) - Manual (Page 2)

Important Notice - Read This First
Exploded Assembly Diagram
Before any tear-down or disassembly begins, review the following information:
• Review the wheel clearance diagram (figure 2, page 3) to verify that there is adequate clearance with the
wheels you will be using with the installation.
• Front brake kits do not include flex lines. OEM brake lines will not adapt to Wilwood calipers. Check the
assembly instructions, or associated components section for brake line recommendations before assembly.
In addition, Wilwood offers an extensive listing of brake lines and fittings on our web site:
www.wilwood.com .
• Due to OEM production differences and other variations from vehicle to vehicle, the fastener hardware and
other components in this kit may not be suitable for a specific application or vehicle.
• It is the responsibility of the purchaser and installer of this kit to verify suitability / fitment of all components
and ensure all fasteners and hardware achieve complete and proper engagement. Improper or inadequate
engagement can lead to component failure.
7
12
13
3
6
21
2
16
25
26
29
24
27
28
31
30
9
15
14
11
10
8
4
22
23
5
1
20
19
18
17
EXISTING
SPINDLE
NUT
EXISTING STEERING
ARM / SPINDLE
SRP DRILLED/SLOTTED PATTERN
GT SLOT PATTERN R/H SIDE SHOWN
FRONT OF
VEHICLE
6 PIST
ON
Figure 1. Typical Installation Configuration
WARNING
INSTALLATION OF THIS KIT SHOULD ONLY BE
PERFORMED BY PERSONS EXPERIENCED IN
THE INSTALLATION AND PROPER OPERATION
OF DISC BRAKE SYSTEMS.
NOTE
SPECIFIC PARTS MAY VARY FROM DIAGRAM
Page 2
Photographic Tip
We suggest you take digital photos of the brake system setup before and during the disassembly procedure. This will aid in the event
that something is not compatible with the new brake components and be a valuable tool to assist in the trouble-shooting process.