Wilwood Dynapro 6 Big Brake Front Brake Kit (Hub) - Manual (Page 3)

Installation of this kit should ONLY be performed by persons experienced in the
installation and proper operation of disc brake systems. Before assembling the
Wilwood front disc brake kit, double check the following items to ensure a
trouble-free installation.
•Make sure this is the correct kit to match the exact make and model year of the
vehicles spindle (i.e., hubs for a 1970 Camaro spindle will not fit a 1982 Camaro
spindle).
•Verify the hub stud pattern in this kit matches the stud pattern of the vehicles wheels.
•Verify wheel clearance utilizing figure 2.
•Inspect the package contents against the parts list to ensure that all
components and hardware are included.
•WARNING: The wheel contact surfaces must seat completely on the face of the
hub. If any contact surfaces overhang the outside diameter of the hub face, a
6.60” diameter x .20” thick steel spacer (Wilwood P/N 300-11961, sold
separately) MUST be used between the wheel and the hub.
Exploded Assembly Diagram
11
1
6
6A
17
16
10
9
13
2A
Z
5
12
7
18
15
3
2
Y
8
4
EXISTING
SPINDLE NUT
SRP DRILLED/SLOTTED
PATTERN
HP PLAIN
PATTERN
14
20
24
23
22
21
19
6 P IS
6PIS
T O
N T ON
26
25
Figure 1. Typical Installation Configuration
WARNING
INSTALLATION OF THIS KIT SHOULD ONLY BE
PERFORMED BY PERSONS EXPERIENCED IN
THE INSTALLATION AND PROPER OPERATION
OF DISC BRAKE SYSTEMS.
NOTE
SPECIFIC PARTS MAY VARY FROM DIAGRAM
FACE OF
HUB
WHEEL STUDS
WHEEL MOUNTING
SURFACE OFFSET
WILWOOD
ROTOR
CENTER
LINE OF
WHEEL
7.00
(177,8)
4.16
(105,6)
INSIDE WHEEL PROFILE
(MINIMUM REQUIRED
FOR CLEARANCE)
0.06 (1,5)
CALIPER
CALIPER
Figure 2. Wheel Clearance Diagram
General Information
Page 3