Grain Systems Bin Accessories PNEG-1112 - Manual (Page 39)

2. Installation
PNEG-1112 Sidewall Bin Stair Assembly 39
NOTE: The handrails are not shipped pre-curved. As the lower and upper handrails are installed, they
must be curved/bent to match the curve of the bin, and in order to attach to the handrail balusters
at the appropriate attachment points.
2. With the next appropriate length handrail, overlap the to-be-installed handrail to the previously
installed handrail. The two (2) handrails should overlap by at least 2''.
Figure 2AV
3. Where the installed handrail(s) meet up with the next higher handrail baluster, use one (1)
1/4'' x 1'' self drilling screw to attach the handrail to the inside surface of the handrail baluster.
The head of the screw should be on the outside surface of the handrail baluster.
Figure 2AW
4. Repeat Previous Steps until the handrail reaches the 51-1/2'' right platform post.