Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1187 - Manual (Page 9)

4
Series 2 Incline Chain Conveyors Safety
PNEG-1187
PRACTICE SAFE MAINTENANCE
Understand service procedures before doing
work. Keep area clean and dry.
Never lubricate, service, or adjust machine while
it is in operation. Keep hands, feet, and clothing
from rotating parts.
Keep all parts in good condition and properly
installed. Fix damage immediately. Replace
worn or broken parts. Remove any build up
grease, oil, or debris.
REMOVE PAINT BEFORE WELDING OR
HEATING
Avoid potentially toxic fumes and dust.
Hazardous fumes can be generated when paint
is heated by welding, soldering, or using a torch.
Do all work outside or in a well ventilated area.
Dispose of paint and solvent properly.
Remove paint before welding or heating:
• If you sand or grind paint, avoid breathing the
dust. Wear an approved respirator.
• If you use solvent or paint stripper, remove
stripper with soap and water before welding.
Remove solvent or stripper containers and
other flammable material from area. Allow
fumes to disperse at least 15 minutes before
welding or heating.