Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1187 - Manual (Page 22)

17
Series 2 Incline Chain Conveyors
PNEG-1187
Maintenance
Before any maintenance is performed to
the conveyor, power must be shut off and
locked out to prevent accidental start up!
The care and maintenance section is provided with the
intention of helping to extend the useful life of the unit.
Like all equipment, the useful life of the conveyor is
greatly reduced if not used wisely and well maintained.
Please follow the next few simple steps to ensure
the safety and longevity of your equipment.
w
Check all bearings and moving parts daily
during use.
w
Lubricate bearings according to bearing
manufacturer’s recommendations.
w
Follow manufacturer’s recommendations for
gear reducer lubrication and maintenance.
w
Inspect the V-belts periodically for proper
tension and wear. V-belts should be
replaced as necessary. If replacement or
tension adjustment is required, please refer to
the Shaft Mount Reducer Assembly Section
on page 15.
w
The Drag Chain and Sprockets should be
checked periodically for wear, damage and
proper adjustment. Any broken or bent
paddles should be replaced or straightened.
Should adjustment or replacement of the
drag chain be required, refer to the
Assembly Section on page 14.
Care and Maintenance Storage
If the unit is to be inactive for an extended period,
the following procedures are recommended.
w
Thoroughly clean the unit.
w
Loosen the drag chain tension. Doing so
relieves the stress placed on the bearings
and shafts of the drive and tail sections.
w
Lubricate drag chains, shafts and drive
components with a good grade of light
machine oil.