Grain Systems Bin Accessories PNEG-066 - Manual (Page 8)

8 PNEG-066 2.66" & 4.00" Side Draw Installation
2.66" Side Draw Systems
16'-4"
EXTERNALL
Y
STIFFENED IS 1-1/3" HIGHER
STIFFENER
COLUMN
VIEWING INSIDE OF
TYPICAL 29 RING BIN
NOTE: Unload tube and supports from
rack & pinion not provided by G.S.I.
14"
(35.56 cm)
7th
SIDEWALL
RING
WIND RING INSTALLATION
Tanks that use wind rings require 2-3/4" dia. holes
passing through the side draw chute; with the center
no less than 6" from either end and 4-3/8" from the
sidewall. The wind ring must penetrate through the
chute and form a complete ring. Do not locate wind
ring in 8" space at chute entrance. Field drill stiffeners
for wind ring attachment bracket. (if required.)
3 Post
7"
(17.78 cm)
6th
SIDEWALL
RING
HORIZONTAL
SEAM
STIFFENER COLUMN
STIFFENER COLUMN
11"
(27.94 cm)
13.5" (34.29 cm)
19"
FIELD CUT
DISCHARGE HOLE
1-1/2" RADIUS
AT CORNERS
(3.80 cm)
4"
(16.16 cm)
(48.26 cm)
18-3/4"
(47.63 cm)
DISCHARGE TUBE INSTALLATION
1.)
Use the bottom 2 holes in the last chute to locate
discharge tube 28" below the 7th horizontal seam. Refer
to Detail "C" for sidewall sheet hole dimensions.
2.) For proper water shed install plate so upper body sheet
overlaps the plate, as shown in Detail "D".
3.) Use discharge tube assembly as a template, drill all holes
7/16" diameter.
4.) Use 2 beads of caulking to seal discharge plate to body
sheets. Use 3/8" bolts & nuts provided to bolt discharge
assembly to body sheets.For all locations where the
sidewall uses 3/8" x 1-1/2" Long Bolts, use the same bolt
to install the discharge tube.
75"
(190.5 cm)
37-1/2"
(95.25 cm)
FIRST CHUTE LOCATION
STIFFENER
COLUMN
DETAIL "C"
(Viewed From Inside Of Bin)
NUMBER OF RINGS CHUTE LOCATION
IN TANK HORIZONTAL STARTING LOCATION
1.) LOCATE 1ST CHUTE IN 2ND RING FROM TOP
ALL 2.) TOP BOLT HOLES IN CHUTE TO BE LOCATED
ON 2ND CORRUGATION OF BODY SHEET
11, 14, 17, 20, 23, 26, 29, & 32, 35 3.) CENTER CHUTE 75 INCHES (LEFT TO RIGHT)
FROM 1ST HOLE IN 2ND BODY SHEET
10, 13, 16, 19, 22, 25, 28, & 31,34, 37 3.) CENTER CHUTE 37.500 INCHES (LEFT TO RIGHT)
FROM 1ST HOLE IN 2ND BODY SHEET
12, 15, 18, 21, 24, 27, 30, & 33, 36 3.) CENTER CHUTE OVER VERTICAL SEAM.
These instructions for 90' diameter tanks and smaller. See
PNEG-972 or PNEG-1343 for 105' diameter tank
sidedraw installation instructions.