Grain Systems Bin Accessories PNEG-066 - Manual (Page 7)

7 PNEG-066 2.66" & 4.00" Side Draw Installation
2.66" Side Draw Systems
VIEWING INSIDE OF
TYPICAL 24 RING BIN
16'-4"
EXTERNALL
Y
STIFFENED IS 1-1/3" HIGHER
STIFFENER COLUMN 56-1/4"
(142.9 cm)
STIFFENER
COLUMN
NOTE: Unload tubes and support from rack &
pinion not provided by G.S.I.
7th
SIDEWALL
RING
DETAIL "C"
14"
(35.56 cm)
7"
(17.78 cm)
HORIZONTAL
SEAM
STIFFENER COLUMN
STIFFENER COLUMN
11"
(27.94 cm)
28-1/8"
(71.44 cm)
13-5" (34.29 cm)
19"
(48.26 cm)
4"
(16.16 cm)
NUMBER OF RINGS IN TANK CHUTE LOCATION
HORIZONTAL STARTING LOCATION
1.) LOCATE 1st CHUTE IN 2nd RING FROM TOP
ALL 2.) TOP BOLT HOLES IN CHUTE TO BE LOCATED
ON 2nd CORRUGATION OF BODY SHEET.
11, 13, 15, 17, 19, 21 & 23 3.) CENTER CHUTE OVER VERTICAL SEAM.
10, 12, 14, 16, 18, 20, 22 & 24 3.) CENTER CHUTE 56.1/4" FROM THE 1st
HORIZONTAL SEAM BOLT IN THE 2nd RING.
DISCHARGE TUBE INSTALLATION
1.) Use the bottom 2 holes in the last chute to locate
discharge tube 28" below the 7th horizontal seam.
Refer to Detail "C" for sidewall sheet hole dimensions.
2.) For proper water shed install plate so upper body
sheet overlaps the plate, as shown in Detail "D".
3.) Use discharge tube assembly as a template, drill all
holes 7/16" diameter.
4.) Use 2 beads of caulking to seal discharge plate to
body sheets. Use 3/8" bolts & nuts provided to bolt
discharge assembly to body sheets.
WIND RING INSTALLATION
Tanks that use wind rings require 2-3/4" dia. holes
passing through the side draw chute; with the center
no less than 6" from either end and 4-3/8" from the
sidewall. The wind ring must penetrate through the
chute and form a complete ring. Do not locate wind
ring in 8" space at chute entrance. Field drill stiffeners
for wind ring attachment bracket. (if required)
FIRST CHUTE LOCATION
6th
SIDEWALL
RING
2 POST
(Viewed From Inside Of Bin)
FIELD CUT
DISCHARGE HOLE
1-1/2" RADIUS AT
CORNERS
(3.80 cm)