Grain Systems Bin Flooring PNEG-1324 - Manual (Page 20)

3. Installation
20 PNEG-1324 72', 75', 78', 90' and 105' Cor-Lok and Cut-Lok Flooring
Flashing Installation
Figure 3E
Grain Systems Formed Flashing Installation
If bin sweep auger is to be used, overlap flashing such that rotation (usually clockwise) of the sweep will
climb up on the next flashing section. This will prevent the rotating/slipping outer wheel of the sweep from
catching on the flashing edges.
(See Figure 3E.)
After the floor is in place, lay the flashing pieces on top of the floor place over the 1-1/4" bin bolts.
See Figure 3F below to determine the correct sequence for placing the nuts and washers. Finger tighten
the nuts. While holding flashing flat, fasten the flashing to the floor with sheet metal screws. Now tighten
flashing nuts.
(See Figure 3E and Figure 3F.)
Figure 3F