Banks Power Dodge Trucks: (Diesel ’98 - 02 5.9L Cummins ISB) Power Systems- Stinger & Git-Kit Systems (does not connect to pump wire) - Manual (Page 2)

1.
For ease of installation of your
Banks Git-Kit or Stinger familiarize
yourself with the procedure by
reading the entire manual before
starting work. This instruction manual
contains
20 pages of text, illustrations
and parts listing.
2.
Throughout this manual, the
left side of the vehicle refers to the
driver’s side, and the right side to the
passenger’s side.
3.
Disconnect the ground cable from
the battery before beginning work.
If there are two batteries, disconnect
both.
4.
Route and tie wires and hoses
a minimum of 6 inches away from
exhaust heat, moving parts and sharp
edges. clearance of 8 inches or more
is recommended where possible.
5.
When raising the vehicle, support
it on properly weight-rated safety
stands, ramps or a commercial hoist.
Follow the manufacturer’s safety
precautions. Take care to balance the
vehicle to prevent it from slipping
or falling. When using ramps, be
sure the front wheels are centered
squarely on the topsides; put the
transmission in park; set the hand
brake; and place blocks behind the
rear wheels.
Caution! Do not use floor
jacks to support the
vehicle while working
under it. Do not raise the
vehicle onto concrete
blocks, masonry or any
other item not intended
specifically for this use.
6.
The installation should be
performed at a time when the vehicle
has been allowed to completely cool.
This installation requires the installer
to work near surfaces that may
remain hot after the vehicle has been
run. Failure to allow the vehicle to
cool may result in personal injury.
7.
During installation, keep your
work area and components clean
to avoid possible dirt entry into the
engine.
8.
Save this owners manual as a
reference for system maintenance
and service.
notification
the Banks ram-air Filter comes
pre-oiled and no oiling is
necessary for initial installation.
Service the filter as specified in
the cleaning and oiling the ram-
air Filter Section of this manual.
general installation Practices
Dear Customer,
If you have any
questions concerning
the installation of
your Banks Power
system, please call
our Technical Service
Hotline at
(888) 839-2700
between 7:00 am and
5:00 pm (PT). If you
have any questions
relating to shipping or
billing, please contact
our Customer Service
Department at
(888) 839-5600.
Thank you.
2 |
9 6 7 6 5 v . 5 . 0