Velleman CAMIP12 Quick Installation Guide - Manual (Page 21)

16
3.6 Trigger
3.6.1 Trigger
You can configure how this camera reacts when there’s an alarm, a motion or a PIR event.
 Detect
Item Description
External Alarm Enable or disable detection from external alarm-in device, and click the title “External Alarm” (in blue) to set “N.O.”
or “N.C.” depending on the configuration of your alarm-in device.
Motion Enable or disable motion detection.
Motion detection is not supported when the stream format is Motion JPEG.
When “Enable” is selected, click “Detection” to enter the motion detection area setting page as follows:
Sensitivity:
Set the detection sensitivity from the drop-down list: High, Normal or Low.
Area Setting:
Set the motion detection area by selecting the area grids with your mouse. Pink grids represent the area that is not being
detected while the transparent grids are the area under detection. You can set multiple areas under detection.
Click “Clear All” to set the whole area undetected.
Click “Select All” to set the whole area under detection.
PIR Enable (ON) or disable (OFF) PIR detection.
Duration Set the duration time for trigger recording (5 / 10 / 20 / 40 seconds).