Velleman CAMIP5N1 Quick Installation Guide - Manual (Page 5)

CAMIP5N1
V. 01 – 08/02/2013 5 ©Velleman nv
2. The camera can be used free standing or in combination with the included mounting bracket. When
the mounting bracket is used, attach it to the wall or ceiling using the 2 included screws. Place the
CAMIP5N1 on top and secure it with the centre screw. Determine the desired angle and tighten the
joint screws.
3. Connect the antenna [6] to the antenna connector and/or connect a network cable (included) to the
8P8C (RJ45) jack [9].
Note: it is possible to connect the camera straight to the 8P8C (RJ45) port of a computer. In this
case a crossed cable (not incl.) should be used and network settings must be configured manually.
4. An external microphone (not incl.) can be connected to the audio input [8].
5. When desired, an external speaker system can be connected to the audio output [7].
6. Plug the DC connector of the power adaptor into the 5VDC input jack [12]. Only use the included
adaptor or one with the same specifications.
7. Plug the adaptor into a suitable mains outlet (100~240V AC/50~60Hz).
Notes:
 It takes about 30s for the camera to initialise.
 During initialisation the camera will start moving to test the pan/tilt functionality.
 If the image appears out of focus, turn the lens [4] to adjust.
6. Manual on CD-ROM
The full version manual on the CD-ROM contains:
 this quick guide
 features
 additional user information
 troubleshooting
 technical specifications.
7. Installing the software
To use the camera, you need to install the software IP Camera Tool on your computer.
7.1 Microsoft Windows
Software requirements
To work with the IP Camera Tool, you need a recent version of one of the following browsers:
 Internet Explorer (32 bits version only)
 Mozilla Firefox
 Google Chrome
 Safari
 Opera
Note: the functions and layout of the surveillance tool vary depending on the browser you are using.
The images in this manual are from Internet Explorer on Microsoft Windows.
Installing the IP Camera Tool
The package contains a cd-rom with the required software.
1. Insert the cd-rom in the computer and locate the software installer (IPCamSetup.exe).
2. Double-click the installer to launch the installation wizard and go through the steps of the wizard.
If you are using Windows XP, you may need to restart your PC to complete the installation.
3. You will find the shortcut IP Camera tool on your desktop.
7.2 Apple Macintosh
Software requirements
To work with the IP Camera Tool, you need a recent version of one of the following browsers:
 Mozilla Firefox
 Google Chrome
 Safari
 Opera