Velleman WIFIR3 - Manual (Page 6)

WIFIR3
V. 01 – 22/08/2013 6 ©Velleman nv
7.1 Connect your router to the repeater
During setup, it is recommended to use a wired connection with the
included RJ-45 network cable.
Once setup is done, you can use the repeater through Wi-Fi.
To connect the router, you need to
• configure network settings on your computer
• configure the repeater in the web management tool
• reset your computer’s network settings
• connect the repeater to your computer
7.2 Configure network settings on your computer
The repeater has a fixed IP address. To be able to access the
repeater during setup, you first need to configure your computer’s
network settings as follows:
1. On your computer, click the Start button and choose
Control Panel > Network & Sharing Center.
2. In the list of networks, click on your network and then click the
Properties button.
3. In the list, select Internet Protocol Version 4 (TCP/IPv4),
then click the Properties button.
4. In the Properties window, select Use the Following
IP Address.
o
In the IP Address box, type 192.168.10.x where ‘x’ is a
number from 2 to 254.