Velleman WS3080 - Manual (Page 5)

WS3080
V. 01 – 21/06/2013 5 ©Velleman nv
 synchronized instant reception
 12 or 24 hour display
 perpetual calendar
 time zone setting
 alarm clock
 LED backlight
 wall mount or standing free
5. Overview
Refer to the illustrations on page 2 and 3 of this manual.
A
upper pole F side support
B lower pole G rain sensor
C top support H solar panel
D anemometer I sensor shelter
E wind vane + direction sensor J thermo-hygrometer (under shelter)
a MENU button d DOWN button ()
b ENTER button e ALARM ON/OFF button( )
c UP button () f HISTORY button
1 Weather forecast 10 Outdoor reception signal
2 Barometric pressure 11 Outdoor humidity
3 Barometric trend 12 Outdoor temperature
4 Date 13 Wind direction
5 Memory 14 Wind speed/gust
6 Time 15 UV index
7 Indoor humidity 16 Rainfall
8 Indoor temperature 17 Light intensity
9 transmitter low battery indicator 18 Radio Controlled Clock (RCC) indicator
6. Setting up the stations
1. Connect the lower pole [B] with the upper pole [A].
2. Place the anemometer [D] on the top support [C] and fix with a bolt and nut.
3. Place the wind vane [E] on the top support [C] and fix with a bolt and nut.
4. Place the top support [C] on top of the upper pole [A] and fix with a bolt and nut.
5. Mount a side support [F] on the pole [A+B] and place the rain sensor [G] on top. Secure it with a screw.
6. Mount the second side support [F] on the pole [A+B].
7. Place the solar panel [H] on top of the shelter [I] and secure it with a bolt and nut.
8. Make all necessary connections:
o Connect the anemometer [D] to the wind vane [E] phone jacket.
o Connect the wind vane [E] to the thermo-hygrometer [J] WIND phone jacket (left).
o Connect the rain sensor to the thermo-hygrometer [J] RAIN phone jacket (right).
9. Insert 2 x AA rechargeable batteries (incl.) into the thermo-hygrometer [J] respecting the polarity as
indicated inside the casing. Only use rechargeable batteries!
10. To ensure DCF reception, immediately insert 3 x AA batteries into the receiver respecting the polarity. Refer
to the section Initialization below for more information on DCF. Note that the receiver is located inside the
thermo-hygrometer
11. Slide the thermo-hygrometer [J] into the shelter [I].
12. Place the thermo-hygrometer [J] on top of the second side support [F] and secure it with a screw.
13. It is strongly recommended to test the station before mounting it outdoors.
14. Wait for the two stations to synchronize. This synchronisation may take a couple of minutes. Do not touch
any button during synchronisation. Once the synchronisation finishes, make sure that all components work
properly.