Atdec Telehook TH-PF Installation manual - Manual (Page 2)

Step 5. Pole Mount
Note: The TH-PF is compatible with 1.5NPT thread.
A range of Pole Accessories are available from Atdec.
1. Install Pole Accessory.
2. Thread mount fully into the end of the Pole.
3. Set the orientation by unwinding the mount. Do
not unwind the mount more than one full turn.
4. Lock the mount in place by tightening the two
security set screws in place using the supplied
security allen key.
Pole Accessory
(Purchased separately
or as part of a kit
from Atdec)
2 MOUNT
4 TIGHTEN
4 TIGHTEN
Step 7. Attach the Legs to the Projector
Leg
Spacer
(optional)
Projector
Projector Mounting
Screw
Note: Washers must be used in conjunction with M2.5 and M3 projector mounting screws.
FOUR FIXING POINTS THREE FIXING POINTS
OR
Step 6. Mounting Projector
Depending on the size of your projector, the
TH-PF has several mounting options available.
Smaller Projectors can be mounted directly to
the Base Plate.
For all other projectors, use the supplied legs.
Projector Mounting
Screw
Base Plate
Projector
Spacer (optional)
Projector Mounting
Screw
Leg
Spacer (optional)
Projector
Washer (optional)
Washer (optional)