Atdec Telehook TH-PF Installation manual - Manual

M2.5x15mm w/ Washer
M3x15/20mm w/ Washer
TH-PF
Component Checklist
Pro AV Projector Ceiling Mount
Square Nut (x4)
Leg (x4)
Coach Bolt (x4)
Nylon
Anchor (x4)
HARDWARE
Projector Mounting Screws (x4 each)
M4x15/20/25mm
M5x15/20/25mm
M6x15/20/25mm
Tools Required:
• Power Drill
• 4mm(0.15”) Drill Bit
• 9mm(0.35”) Masonry Drill Bit
• Phillips Head Screwdriver
• 13mm (0.5”) Socket Wrench/ Shifter
! IMPORTANT - Install Telehook Projector Ceiling Mount as per installation instruction.
! This product supports a maximum load of 25kg (55lbs.).
! The manufacturer accepts no responsibility for incorrect installation.
IMPORTANT INFORMATION:
Step 1. Check Components
Check you have received against the component checklist and hardware above.
M6 Washer (x4)
Mount
Step 2. Cable Management
Step 4. Ceiling Mount
Base Plate
10mm Spacer
(x4 each)
M5x10mm Socket
Head Screw (x4)
M5x10mm
Security Screw
3mm Security
Allen Key
Security Cap (x4)
The TH-PF can be mounted flush to a ceiling (Step 4) or to a pole (Step 5).
Before mounting your TH-PF, give consideration to your cable route. The
TH-PF has provision for cable management as shown below.
Step 3. Choosing Orientation
Ensure the Mount is attached with the Projector Marks pointing in the same
direction that the projector will be facing.
Projector Mark
Projector Mark
IMPORTANT! Any structural elements must be capable of supporting the combined weight of
all the equipment and devices being mounted. If in doubt, consult a structural engineer.
Timber Stud Masonry
Coach Bolt
M6 Washer
Mount
TIP: Use Mount as a drilling template.
Coach Bolt
M6 Washer
Mount
Ø9mm x 40mm deep
Drilled Hole
Ø4mm x 35mm deep
Drilled Hole
Installation Instructions