Brother NX-2000 - Manual (Page 9)

7
E
NGL
ISH
m
Lightly hold the end of the upper thread, and
then turn the handwheel toward you so the
mark on the handwheel aligns with the line on
the machine.
n
Gently pull the upper thread to pull up the
bobbin thread through the needle plate.
→ A loop of the bobbin thread comes out through the
hole in the needle plate.
o
Use the presser foot lever to raise the presser
foot.
p
Insert tweezers through bobbin thread loop
and pull bobbin thread above the needle
plate.
q
Align the upper thread and bobbin thread,
and then pull out about 10 cm (approx.
4 inches) of the threads and pass them under
the presser foot toward the rear of the
machine.
r
Install the needle plate cover and the bobbin
cover.
For details on installing the needle plate cover,
refer to “Cleaning the Race” in the Operation
Manual.
a Needle plate cover
b Bobbin cover
s
Install the flat bed attachment.
t
Press or in the
screen.
→ All keys and operation buttons are unlocked, and
the previous screen is displayed.
CAUTION
• When creating bobbin work, use the bobbin cover
with tabs, otherwise the thread may become
tangled or the needle may break.
Note
• When installing the needle plate cover, do not allow
it to pinch the thread.
Note
• When installing the flat bed attachment, do not allow
it to pinch the thread.
Note
• When the bobbin thread is replaced with a new one,
be sure to repeat the procedure from a , otherwise
the lower threading will not be done correctly.