VEGA VEGAFLEX 86 Foundation Fieldbus Coax probe - Manual (Page 2)

2
Quick start
VEGAFLEX 86 • Foundation Fieldbus
44230-EN-130910
Quick start
The quick start procedure enables a quick setup of the instrument
with many applications. You can find further information in the respec-
tive chapters of the operating instructions manual.
→
The probe must not touch any installations or the vessel wall.
For further information see chapter "Mounting".
1. Make sure that the power supply corresponds to the specifica-
tions on the type label.
2. Connect the instrument according to the following illustration
5
0 0
5
1
6
2
7 3 8
4
9 0
5
1
6
2
7 3 8
4
9 1
0
1
6 7 8
Bus
2
3
4
5 1 2 + ( ) (-)
1
Fig. 1: Electronics and connection compartment, single chamber housing
1 Voltage supply, signal output
2 For display and adjustment module or interface adapter
3 Selection switch for bus address
4 For external display and adjustment unit
5 Ground terminal for connection of the cable screen
For further information see chapter "Connecting to power supply".
For standard applications we recommend selecting the "Quick setup"
in the display and adjustment module.
1. In this menu item you can select the application. You can choose
between level and interface measurement.
2. In the menu item "Medium - Dielectric constant" you can define
the type of medium (medium).
3. Carry out the adjustment in the menu items "Min. adjustment" and
"Max. adjustment".
4. A "Linearization" is recommended for all vessels in which the
vessel volume does not increase linearly with the level - e.g. in a
Mounting
Electrical connection
Set parameters