VEGA KV 31 Mounting brackets For tubes with ø 50…100 mm - Manual (Page 9)

1
3
4
2
Fig. 5: Adjust mounting bracket
1 Console
2 Bracket, sensor or source holder side
3 Screw connections
4 Markings (different tube diameters)
Mount the bracket according to the following assembly drawing:
Tip:
The mounting bracket is very heavy. We recommend using a support,
eg of wood, as a mounting aid to hold the mounting bracket at the
proper height during installation.
1 Before mounting, check if the adjustment with respect to the tube
diameter is correct on both sides of the mounting bracket and if the
marking arrows of the console and the collimator (optional) point in
the same direction.
2 Make sure that the two clamps (5 and 8) of the bracket are in
parallel. Do this by measuring the lateral distances between the
clamps.
3 Tighten the nuts of the threaded rod evenly. Keep the tube
diameter and the stability of the tube material in mind. Avoid
deformation of the tube through an overtightening of the mounting
bracket.
Installation of the
mounting bracket
Mounting brackets KV 31 • Source holder SE 9
2 Mounting
41863
-
EN
-120228