VEGA KV 31 Mounting brackets For tubes with ø 50…100 mm - Manual (Page 12)

9 Bracket - sensor side (MINITRAC)
10 Tube ø 50 … 100 mm (1.97 … 3.94 in)
x Brackets in parallel - distances on both sides the same
A The marking arrow and the lug point in the same direction
Once the mounting bracket is installed, you can mount the sensor and
the source holder.
You can find the torque in the "Technical data".
Danger:
When mounting, make sure that the source holder is reliably switched
off.
1 First of all fasten the sensor.
2 Mount the source holder. Use a suitable lifting device and note the
respective safety regulations for lifting loads.
Mount the sensor and
source holder
12 Mounting brackets KV 31 • Source holder SE
2 Mounting
41863
-EN
-120228