VEGA VEGABAR 83 Profibus PA - Operating Instructions - Manual (Page 12)

12
3 Product description
VEGABAR 83 • Profibus PA
45037-EN-131107
You can find further information in the supplementary instructions
"Adapter DISADAPT" (Document-ID 45250).
The protective cover protects the sensor housing against soiling and
intense heat from solar radiation.
You will find additional information in the supplementary instructions
manual "Protective cover" (Document-ID 34296).
Screwed flanges are available in different versions according to the
following standards: DIN 2501, EN 1092-1, BS 10, ANSI B 16.5,
JIS B 2210-1984, GOST 12821-80.
You can find additional information in the supplementary instructions
manual "Flanges according to DIN-EN-ASME-JIS" (Document-ID
31088).
Welded sockets are used to connect the sensors to the process.
You can find further information in the supplementary instructions
"Welded socket VEGABAR series 80" (Document-ID 45082).
The electronics module VEGABAR series 80 is a replacement part
for pressure transmitters of VEGABAR series 80. There is a different
version available for each type of signal output.
You can find further information in the operating instructions "Elec-
tronics module VEGABAR series 80" (Document-ID 45054).
The supplementary is a replacement part for the following sensors
with signal output Profibus PA:
•
VEGAPULS series 60
•
VEGAFLEX 80 series
•
VEGABAR series 80
You can find further information in the operating instructions "Supple-
mentary electronics for Profibus PA" (Document-ID 42767).
Protective cap
Flanges
Welded socket
Electronics module
Supplementary electron-
ics Profibus PA