VEGA VEGABAR 81 Modbus and Levelmaster protocol - Operating Instructions - Manual (Page 11)

11
3 Product description
VEGABAR 81 • Modbus and Levelmaster protocol
46293-EN-131107
For sensors with double chamber housing the interface adapter "DIS-
ADAPT" is also required for VEGADIS 81.
You can find further information in the operating instructions "VE-
GADIS 81" (Document-ID 43814).
The adapter "DIS-ADAPT" is an accessory part for sensors with
double chamber housings. It enables the connection of VEGADIS 81
to the sensor housing via an M12 x 1 plug.
You can find further information in the supplementary instructions
"Adapter DISADAPT" (Document-ID 45250).
The protective cover protects the sensor housing against soiling and
intense heat from solar radiation.
You will find additional information in the supplementary instructions
manual "Protective cover" (Document-ID 34296).
Screwed flanges are available in different versions according to the
following standards: DIN 2501, EN 1092-1, BS 10, ANSI B 16.5,
JIS B 2210-1984, GOST 12821-80.
You can find additional information in the supplementary instructions
manual "Flanges according to DIN-EN-ASME-JIS" (Document-ID
31088).
Welded sockets are used to connect the sensors to the process.
You can find further information in the supplementary instructions
"Welded socket VEGABAR series 80" (Document-ID 45082).
The electronics module VEGABAR series 80 is a replacement part
for pressure transmitters of VEGABAR series 80. There is a different
version available for each type of signal output.
You can find further information in the operating instructions "Elec-
tronics module VEGABAR series 80" (Document-ID 45054).
The supplementary electronics is a replacement part for sensors with
signal output Modbus.
You can find further information in the operating instructions "Supple-
mentary electronics Modbus" (Document-ID 41864).
DIS-ADAPT
Protective cap
Flanges
Welded socket
Electronics module
Supplementary electron-
ics Modbus