VEGA VEGAFLEX 81 4 … 20 mA_HART - four-wire - Manual (Page 2)

2
Quick start
VEGAFLEX 81 • 4 … 20 mA/HART - four-wire
41825-EN-130314
Quick start
The quick start procedure enables a quick setup with many applica-
tions. You can find further information in the respective chapters of the
operating instructions manual.
1. Distance from the metallic vessel wall > 300 mm. Distance from
non-metallic vessel wall > 500 mm. The probe must not touch any
installations or the vessel wall.
2. Place a metal sheet beneath the process fitting with non-metal
vessels.
1 2
Fig. 1: Installation in non-metal vessel
1 Flange
2 Metal sheet
3. If necessary, fasten probe end.
For further information see chapter "Mounting".
1. Make sure that the power supply corresponds to the specifica-
tions on the type label.
2. Connect the instrument according to the following illustration
power supply
4...20mA
active passive common IS GND
5 1
/L
/N
PE
2 + ( ) (-) 6 7 8
Fig. 2: Connection compartment with double chamber housing with mains
voltage
For further information see chapter "Connecting to power supply".
For standard applications we recommend selecting the "Quick setup"
in the display and adjustment module.
Mounting
Electrical connection
Set parameters