VEGA VEGAPULS 66 (≥ 2.0.0 - ≥ 4.0.0) standpipe ver. Modbus and Levelmaster protocol - Manual (Page 10)

10
3 Product description
VEGAPULS 66 standpipe version • Modbus and Levelmaster protocol
41367-EN-121011
2
1
Fig. 3: Position of Modbus and sensor electronics
1 Modbus electronics
2 Sensor electronics
This operating instructions manual applies to the following instrument
versions:
•
Hardware from 2.1.0
•
Software from 4.5.1
The instrument is available in two different sensor electronics ver-
sions. The selection depends on the application area, see chapter
"Principle of operation".
The respective version can be determined via the product code on
the type label as well as on the electronics.
•
Standard electronics type PS60HK.-
•
Electronics with increased sensitivity type PS60HS.-
The scope of delivery encompasses:
•
Radar sensor
•
Documentation
– this operating instructions manual
– Test certificate Measurement accuracy, depending on the
instrument VEGAPULS 66 (optional)
– Operating instructions manual "Indicating and adjustment mod-
ule PLICSCOM" (optional)
– Supplementary instructions manual "Heating for indicating and
adjustment module" (optional)
– Supplementary instructions manual "Plug connector for con-
tinuously measuring sensors" (optional)
– Ex-specific "Safety instructions" (with Ex versions)
– if necessary, further certificates
3.2 Principle of operation
The instrument is suitable for the measurement of liquids under dif-
ficult and extreme process conditions. Application possibilities can
be found in the chemical industry, in environmental and recycling
technology as well as in the petrochemical industry.
The version with standpipe antenna is particularly suitable for
measurement of solvents and liquid gases, for vessels with foam
generation or for measurement of products with low dielectric values
(DK > 1.6).
Scope of this operating
instructions manual
Versions of the sensor
electronics
Scope of delivery
Application area