VEGA VEGAPULS 65 (≥ 2.0.0 - ≥ 4.0.0) Profibus PA - Manual (Page 40)

40
6 Set up with the indicating and adjustment module
VEGAPULS 65 • Profibus PA
36517-EN-121011
•
Peak values measured value: Resetting of the measured min.
and max. distances to the actual measured value.
Select the requested reset function [->] and confirm with [OK].
The following table shows the default values of VEGAPULS 65:
Menu Menu item Default value
Setup Measurement
loop name
Sensor
Medium Liquid/Water
Bulk solids/Crushed stones, gravel
Applications Storage tank
Silo
Vessel form Vessel bottom, dished boiler end
Vessel top, dished boiler end
Vesell height/
Measuring range
Recommended measuring range, see
"Technical data" in the supplement
Min. adjustment Recommended measuring range, see
"Technical data" in the supplement
Max. adjustment 0,000 m(d)
AI FB1 Channnel PV (lin. perc.)
AI FB1 scaling
unit
Height
%
AI FB1 scaling 0.00 lin %, 0.00 %
100.00 lin %, 100.00 %
AI FB1 damping 0 s
Lock operation Released
Display Language Like order
Displayed value SV 1
Backlight Switched off
Additional adjust-
ments
Distance unit m
Temperature unit °C
Unit SV2
m
Probe length Length of the standpipe Ex factory
Linearisation
curve
Linear
Sensor address 126
6.4 Saving the parameter adjustment data
We recommended noting the adjusted data, e.g. in this operating
instructions manual, and archiving them afterwards. They are thus
available for multiple use or service purposes.
If the instrument is equipped with an indicating and adjustment
module, the data in the sensor can be saved in the indicating and