VEGA PLICSMOBILE GSM_GPRS radio module - Manual (Page 16)

DTM menu "Network information" under "Setup - Diagnosis". You can
also see the general device status via the status indication.
The following operating conditions are signalled via the LED
status indication:
l
LED does not light: no operating voltage or power saving mode
active
l
Constant flashing: Instrument is not logged into the GSM
network
l
Unsteady flashing (long OFF/short ON): instrument is booked
into the GSM network
l Continuous light: Transmitting or dia-up connection (via CSD)
active
When PLICSMOBILE is in power saving mode, a login procedure can
be triggered via the test key. The user can thus check via the status
LED if logging into the GSM network is possible.
5 .5 Internet connection and measured value
transmission
The transmission of measured values via e-mail or to the
visualization software WEB-VV is always based on an Internet
connection. Access data (user name/password) are required for this
connection. With a GSM connection also a dial-in number is required,
with a GPRS connection the APN (Access Point Name) must be
stated. You can get this information from your mobile phone provider.
You can find further information and a list of the standard mobile phone
providers with their access data in the Online help of the PLICS-
MOBILE DTM.
Status indication
Internet connection (Di-
al-Out)
16 PLICSMOBILE • GSM/GPRS radio module
5 Set up
36849
-EN
-111221