VEGA VEGABAR 55 Profibus PA - Manual (Page 11)

11
3 Product description
VEGABAR 55 • Profibus PA
36735-EN-130321
VEGADIS 61 is suitable for external measured value indication and
adjustment of plics® sensors. It is connected to the sensor with an up
to 25 m long, four-wire, screened standard cable.
You can find further information in the operating instructions "VE-
GADIS 61" (Document-ID 27720).
Flanges are available in different versions according to the following
standards: DIN 2501, EN 1092-1, ANSI B 16.5, JIS B 2210-1984,
GOST 12821-80.
You can find additional information in the supplementary instructions
manual "Flanges according to DIN-EN-ASME-JIS" (Document-ID
31088).
The measuring instrument holder is used for wall/tube mounting of
VEGABAR series 50 pressure transmitters and VEGAWELL 52 sus-
pension pressure transmitters. Supplied reducers enable the adapta-
tion to different instrument diameters. The material used is 316L.
The protective cover protects the sensor housing against soiling and
intense heat from solar radiation.
You will find additional information in the supplementary instructions
manual "Protective cover" (Document-ID 34296).
The electronics module is a replacement part for pressure transmitter
VEGABAR. One version is available for each type of signal output.
You find further information in the operating instructions "Electronics
module VEGABAR series 50 and 60 " (Document-ID 30175).
External display and
adjustment unit
Flanges
Measuring instrument
holder
Protective cover
Electronics module