VEGA VEGACAL 67 Foundation Fieldbus - Manual (Page 28)

28
6 Set up with the display and adjustment module PLICSCOM
VEGACAL 67 • Foundation Fieldbus
31760-EN-130917
Service
Basic adjustment 4
Display
Diagnostics
▶ Service
Info
Simulation 4.1
Start simulation?
Reset 4.2
Select reset?
Language 4.3
German
Copy sensor data 4.4
Copy from sensor
Copy to sensor
PIN 4.5
Enable?
Info
Basic adjustment 5
Display
Diagnostics
Service
▶
Info
Device ID 5.1
< max. 32 characters >
Sensor-TAG (PD_TAG)
< max. 32 characters >
Instrument type 5.2
VEGACAL 6x
Serial number
12345678
Date of manufacture 5.3
06. February 2012
Software version
1.30
Last change using PC 5.4
05. March 2012
Sensor characteristics 5.5
Display now?
6.10 Saving the parameter adjustment data
We recommended noting the adjusted data, e.g. in this operating
instructions manual, and archiving them afterwards. They are thus
available for multiple use or service purposes.
If VEGACAL 67 is equipped with a display and adjustment module,
the most important data can be read out of the sensor into the display
and adjustment module. The procedure is described in the operating
instructions manual "Display and adjustment module" in the menu
item "Copy sensor data". The data remain there permanently even if
the sensor power supply fails.
If it is necessary to exchange the sensor, the display and adjustment
module is inserted into the replacement instrument and the data are
written into the sensor under the menu item "Copy sensor data".