VEGA VEGACAP 65 - Relay (DPDT) - Manual (Page 29)

29
9 Supplement
VEGACAP 65 • - Relay (DPDT)
30016-EN-130916
Sensor length (L) 0.4 … 32 m (1.312 … 105 ft)
Max. tensile load (cable)
Ʋ PTFE partly insulated: ø 6 mm
(0.236 in)
10 KN (2248 lbs)
Ʋ PTFE partly insulated: ø 8 mm
(0.315 in)
10 KN (2248 lbs)
Ʋ PA partly insulated: ø 11 mm (0.433 in) 10 KN (2248 lbs)
Max. torque (process fitting - thread) 100 Nm (74 lbf ft)
Measuring frequency 430 kHz
Output variable
Output
Relay output (DPDT), 2 floating spdts
Switching voltage
Ʋ Min. 10 mV
Ʋ Max. 253 V AC, 253 V DC
With circuits > 150 V AC/DC, the relay contacts must be
in the same circuit.
Switching current
Ʋ Min. 10 µA
Ʋ Max. 3 A AC, 1 A DC
Breaking capacity
Ʋ Min. 50 mW
Ʋ Max. 750 VA AC, 54 W DC
If inductive loads or stronger currents are switched
through, the gold plating on the relay contact surface will
be permanently damaged. The contact is then no longer
suitable for switching low-level signal circuits.
Contact material (relay contacts) AgNi (Au plated) or AgSnO (Au plated)
Modes (switchable) Min./Max.
Switching delay
Ʋ When immersed 0.7 s
Ʋ When laid bare 0.7 s
Ʋ In case of failure 1 s
Ambient conditions
Ambient temperature on the housing
-40 … +80 °C (-40 … +176 °F)
Storage and transport temperature -40 … +80 °C (-40 … +176 °F)
Process conditions
Process pressure
Ʋ Standard -1 … +64 bar/-100 … 6400 kPa (-14.5 … 928 psig)
Ʋ with screening tube adapter (PN1) 0 … +1 bar/0 … 100 kPa (0 … 14.5 psig)
Process temperature VEGACAP 65 of 316L
Ʋ Insulation PA -50 … +80 °C (-58 … +176 °F)