VEGA VEGABAR 65 4 … 20 mA_HART - Manual (Page 13)

1
2
Fig. 4: Temperature ranges
1
Process temperature
2 Ambient temperature
4.2 Mounting steps
F or mounting VEGABAR 65, a welded socket is required. You can find
these components in the supplementary instructions manual "Welded
socket and seals".
U se the seal corresponding to the instrument:
- or -
S eal with a suitable resistant seal:
l F lange connection according to DIN/ANSI
à Screw VEGABAR 65 into the welded socket. Tighten the hexagon
screw on the process fitting with SW 27 (spanner width 27 mm).
Warning:
T
he housing must not be used to screw the instrument in! Applying
tightening force can damage internal parts of the housing.
U se the seal corresponding to the instrument:
- or -
S
eal with a suitable resistant seal:
l F lange connection according to DIN/ANSI
à Screw VEGABAR 65 into the welded socket. Tighten the hexagon
screw on the process fitting with SW 27 (spanner width 27 mm).
Warning:
T
he housing must not be used to screw the instrument in! Applying
tightening force can damage internal parts of the housing.
Welding the socket
Sealing/Screwing in
Sealing/Screwing in
VEGABAR 65 • 4 … 20 mA/HART 13
4 M ounting
27531
-
EN
-081209