VEGA VEGABAR 61 Profibus PA - Manual (Page 30)

5.8 Switch on phase
After VEGABAR 61 is connected to voltage supply or after voltage
recurrence, the instrument carries out a self-check for approx. 30
seconds. The following steps are carried out:
l Internal check of the electronics
l Indication of the instrument type, the firmware as well as the
sensor TAGs (sensor designation)
l Status byte goes briefly to fault value
Then the current measured value will be displayed and the
corresponding digital output signal will be outputted to the cable.
3)
3) The values correspond to the actual measured level as well as to the set-
tings already carried out, e.g. default setting.
Switch on phase
30 VEGABAR 61 • Profibus PA
5 Connecting to power supply
28251
-EN
-081209