VEGA Capacitive electrodes EK 4 … 20 mA - Compact - Manual (Page 35)

Capacitive electrodes EK 4 … 20 mA - Compact 35
22574-EN-020809
Setup
1.2.3.1.1
1.2.3.1.2
Note:
After adjustment of a parameter push ” ENTER“ and then ”SEND“.
Confirm the message to switch over the meas. circuit to manual operation
with ”
OK“.
Confirm the message to change over to automatic operation also with ” OK“.
Only then the adjustment is written in the sensor and is effective.
Menu windows are displayed but not
supported by the sensor.
Saving of the adjustments carried out
here, is hence not possible.
1.4.3.1.3
1.4.3.1.2
High: Current output goes to < 3,6 mA
in case of failure
1.4.3.2
1.4.3.1
}
Off
On
Not used
None
Unknown
Special Sensor signals measured values only upon
request
Sensor signals measured values unsolicited
Choice is not supported
1.4.3.2.3
1.4.3.2.4
Burst mode should be off
Choice is not supported
1.2.3.1.1.1
1.2.3.1.2.1
1.4.3.1.3
1.4.3.1.3.1
Generic: Sensor
Current applied
process value:
10.945
mbar
1 Set as 4 mA value
2 Read new value
3 Leave as found
ABORT ENTER
Generic: Sensor
Current applied
prosess value :85.281
mbar
1 Set as 20 mA value
2 Read new value
3 Leave as found
ABORT ENTER
Generic: Sensor
Choose analog output
level
1 4 mA
2 20 mA
3 Other
4 End
ABORTENTER
Generic: Sensor
WARN - Loop should be
removed from
automatic control
ABORT OK
Generic: Sensor
Set the:
1 4 mA
2 20 mA
3 Exit
ABORT ENTER
Generic: Sensor
Set the:
1 4 mA
2 20 mA
3 EXIT
ABORT ENTER
Generic: Sensor
AO Alrm typ
Hi
EXIT
Generic: Sensor
HART output
1 Poll addr
2 Num req preams
3 Burst mode
4 Burst option
HELP SAVE HOME
Generic: Sensor
Analog output
1 AO1 13.467
2 AO Alrm typ
3 Loop test
4 D/A trim
5 Scaled D/A trim
HELP SAVE HOME
Generic: Sensor
Fld dev output is
fixed at 4.000 mA
ABORT OK
Generic: Sensor
Burst mode
Off
Off
On
Not Used
None
ESC ENTER
Generic: Sensor
Burst option
*********
PV
% range/current
Process vars/crnt
HELP ESC ENTER