VEGA VEGATOR 537 Ex - Manual (Page 6)

6 VEGATOR 537 Ex
23465-EN-030723
Mounting
Mounting single housing
You can either screw the socket directly onto
the mounting plate or plug it onto the carrying
rail (TS 35 x 7.5 acc. to EN 50 022 or TS 32
acc. to EN 50 035). Connect the terminals to
the basic board acc. to the wiring diagram on
the following pages. For further mounting
information, see operating instructions of the
housing.
Transparent cover
The front panel of VEGATOR can be fitted
with a sealable transparent cover to prevent
unauthorized or inadvertent use. The cover is
provided with the instrument.
2 Mounting
VEGATOR can be either installed with a mod-
ule into a carrier BGT 596 or a single housing
type 505.
Module (33)
for VEGATOR 537
Multipoint connector DIN 41 612, series F,
33-pole (d, b, z) with coded pin and material
for mounting into carrier BGT 596.
Module Ex (33 Ex)
for VEGATOR 537 Ex
Multipoint connector DIN 41 612, series F,
33-pole (d, b, z) with coded pin and material
for mounting into carrier BGT 596 Ex.
Single housing
Plastic housing type 505 for single mounting
of signal conditioning instruments with instru-
ment width 5 TE (25.4 mm).
Mounting carrier
Mount the respective module (standard or Ex
version) on the carrier BGT 596. Wire the
multipoint connector acc. to the wiring dia-
grams on the following pages.
The multipoint connector is available in the
following versions:
- Wire-Wrap standard connection
1.0 x 1.0 mm
- plug connection 2.8 x 0.8 mm
- Termi-Point standard connection
1.6 x 0.8 mm
- soldering connection
- screw terminals 2 x 0.5 mm
2
For further information concerning mounting,
see operating instructions of the carrier.