VEGA VEGABAR 41 Profibus PA - Manual (Page 24)

24 VEGABAR 41 (Profibus PA)
Setup
Information about the sensor ident
number:
You do not have to modify the adjustment
"VEGA specific No.“. Only if you want to
make sure that VEGABAR can be replaced
on the Profibus by a sensor of another manu-
facturer, do you have to choose the option
"Profile specific No.“.
Configuration measurement loop
Click to Configuration , point to Measure-
ment loop , then click to Modify .
Now all instruments which are connected to
the bus are shown (identifiable by the bus
address and the serial number). Notice that
in this example the same serial number
appears twice. This is a sensor with a
measurement loop for pressure and a se-
cond measurement loop for temperature.
Choose the sensor (the measurement loop)
with which you want to create a measurement
loop and click to
OK .
In the window "Modify meas. loop
configuration“ you can assign a name and a
description to the measurement loop. State
under "Application“ if you want to create a
process pressure or level measurement.
With
OK you return again to the window
"VEGA Visual Operating“. In the following
explanations, we assume that you have cho-
sen the application "Process pressure meas-
urement“. The adjustment "Level
measurement“ differs slightly from the
following presentation.
The menu language of the sensor can be
selected (only relevant with a sensor with
menu-driven adjustment) and the units for the
output of the sensor values can be set. If
address 126 is adjusted on the sensor, you
can assign a bus address to the sensor in
the field "Sensor address“. Then click to
Save .