Velleman К8059 - Manual (Page 8)

8
The transmitter comes with a factory set default code. However, for security reasons, it might be wise not to
use the default code.
1. To program your unique code :
Hold SW1(*) (left button).
Briefly press the 'program'-button (SW3) 3 times. The LED will flash 3 times.
Release SW1.
Your unique 32-bit code has been generated and stored.
(*If you hold SW2 (right button) instead of SW1 (left button), the unit will generate and store your unique 32-
bit code and the transmitter will be configured in such a way that continuous transmission is not possible i.e.
if you hold either button transmission will stop after a +/- 1s)
2. To return to the default code :
Hold SW1 (left button).
Hold the 'program'-button (SW3).
After +/- 10s the led will flash 5 times.
Release both buttons.
Your code has been erased.
To set a new code, see point 1.
Use
13. Use