Velleman VM152 User Manual
Page 6
6
Changing the code :
Return to the default code :
1. Hold SW1 (left button)
2. Briefly press the 'program'-button (SW3) 3 times. The LED will flash 3 times.
3. Release SW1.
4. Your unique 32-bit code has been generated and stored.
1. Hold SW1 (left button).
2. Hold the 'program'-button (SW3). After +/- 10s the led will flash 5 times.
3. Release both buttons.
4. Your code has been reset to the default code.
Turn off the power (disconnect power supply)
Hold buttons 3 & 4 pressed
Turn on power (connect power supply)
The Led's start flashing
Release buttons 3 & 4 after the LED’s turn off
This process takes about 10 seconds.
If the button is released before the LED’s turn off, the memory will not be cleared.
The unit will now respond to the default code only. please also reset the transmitter to the
default code.
Receiver: remove all learned remotes from memory and return to default code
Transmitter
3
4
SW3
SW1
SW2
LED
transmitter & receiver settings
vm152G'1_rev2.pub
page 6
Wednesday, September 26, 2012 14:16