Ohaus CW-11 Indicator - Manual (Page 31)

28
CW-11 Indicator
4.OPERATION (Cont.)
4.8 Establishing a New Average Piece Weight
(APW)
If the APW has not been calculated previously, pro-
ceed as follows:
Press and hold PRINT/UNITS button until Pcs cursor
is displayed.
Press and hold G/N/T/MENU until SEtPCS is dis-
played. This is displayed for about 1 second, then
SEt 5 is displayed.
*
Gross
Brutto
Pcs Center
of Zero
*
Pcs Net
Select an alternate sample size by pressing and
holding PRINT/UNITS button. Choices are 5, 10,
20, and 50. Place count samples on platform.
Press G/N/T/MENU button to accept current sample.
The new APW is established. Place parts on plat-
form or in a container to count. If a container is
used, be sure to tare the empty container first.
Additional parts may be added to the platform as
long as the same sample weight intially entered is
the same as the parts being weighed.
4.9 Returning to a Weighing Mode
Press PRINT/UNITS button until the display indicates
the desired measuring unit either kg, lb or g.
*
Pcs Net
*
Pcs Net
Pcs Net
*
Pcs Gross
Brutto
*
k g
*
Gross
Brutto
Center
of Zero
4.10 Returning to a Preset APW
If the APW has been calculated previously, the Indica-
tor stores the value in memory. Proceed as follows to
use a previously set APW:
Press and hold PRINT/UNITS button until Pcs cursor
is displayed.
Place samples on the platform. The display indi-
cates the number of pieces based on the previously
entered data. Sample shown at left indicates 100
pieces.
CAUTION
WHEN POWER IS TURNED OFF, APW
WILL ALWAYS RETURN TO DEFAULT APW 5. P c s G r o s s
Brutto
S t a b l e
*
Pcs Center
of Zero
Gross
Brutto