Cw-11 indicator – Ohaus CW-11 Indicator User Manual

Page 22

CW-11 Indicator

DATA

Press G/N/T/MENU button, dAtA 7 is displayed.
This is the data length.

Press PRINT/UNITS button, and select desired data
length of 7 or 8. Default setting is 7.

STOP BITS

Press G/N/T/MENU button, StOP 2 is displayed. This
is the stop bit.

Press PRINT/UNITS button, and select desired stop
bit of 1 or 2. Default setting is 2.

AUTO PRINT
Auto print has settings which enables data to a printer
or PC to be set Off, run continuously, at selected preset
intervals or on stability. On stability will print first stable
non-zero value after each change in weighing value.

Press G/N/T/MENU button, AP OFF is displayed.

Press PRINT/UNITS button, and select either Off,
Continous, Interval or On Stability. Default setting is
OFF.

INTERVAL - PRINTING
When interval has been selected in the previous step,
you may now set an interval from 1 to 3600 seconds.

Press G/N/T/MENU button, int is displayed, after a
few seconds, a second display appears which
allows you to set in the time in seconds.

Pressing the PRINT/UNITS button advances the zero
from left to right. Sample at left indicates 10 sec-
onds.

NOTE: 0000 not valid.

2.8 Initial Scale Setup (Cont.)

2.8.6 Print Menu (Cont.)

Procedure (Cont.)