Ohaus TS Series Electronic Balance - Manual (Page 61)

4
INTRODUCTION INTRODUCTION INTRODUCTION INTRODUCTION INTRODUCTION
The RS232 Interface Accessory is a
bidirectional interface which enables ei-
ther a Precision Standard or an Analytical
Standard balance to communicate with a
printer or computer equipped with an
RS232 serial port. The interface assembly
is easily installed in the balance and com-
munication parameters are configured
through the balance’s front panel.
INSTALLATION INSTALLATION INSTALLATION INSTALLATION INSTALLATION
Use the following procedure to install the
RS232 Interface accessory.
CAUTION CAUTION CAUTION CAUTION CAUTION
TO PREVENT DAMAGE TO THE BAL-
ANCE, BE CERTAIN THAT POWER IS
DISCONNECTED BEFORE REMOVING
THE COVER.
1. Disconnect power to the balance.
2. Remove the draft shield (if in-
stalled).
3. Remove the pan and pan support.
4. Using a philips screwdriver, re-
move the three screws and washers
which secure the cover to the bal-
ance. The balance will have to be
turned over or on its side to access
the screws as they are located
on the bottom; two under the
front panel and one on the rear.
CAUTION CAUTION CAUTION CAUTION CAUTION
HOLD THE COVER AND BASE TO-
GETHER WHILE REMOVING SCREWS.
DO NOT ALLOW COVER OR BASE TO
FALL.